The installation steps of Sanitary Ball Valve are as follows:
1. Remove the protective covers on both sides of the flange end and flush and clean the sanitary ball valve body with the valve body open;
2. Before installation, the whole machine must be tested according to the specified signal, and it can be installed online only after passing the test;
3. Before preparing to connect to the pipeline, the remaining impurities in the pipeline must be flushed and cleaned;
4. During installation, do not use the actuator part that is not a ball valve as a lifting point to avoid damage to the actuator and accessories;
5. This type of sanitary ball valve should be installed in the horizontal or vertical direction of the pipeline;
6. The pipeline near the installation point of the stainless steel ball valve must not be drooping or subjected to external forces. Pipeline brackets or supports can be used to solve the deviation of the pipeline;
7. After connecting to the pipeline, cross-tighten the flange connection bolts with the specified torque.